HSI selected in PLL Source Mux (HSI – High Speed Internal clock)Ģ. In the Clock Configuration tab, check that STM32CubeMX automatically configures the internal oscillator in the clock system with PLL and proposes the PLL configuration as follows:ġ. Click on the Chip view, to stop blinking. When found, the pin or set of pins that matches the search criteria blinks on the Chip view.
Pinout search field allows the user to search for a pin name, signal name, or signal label in the Pinout view. The signals can be set directly from the pinout view: Click on Chip view to stop the blinking.When found, the pin that matches the search criteria blinks on the Chip view.Type “LED” in the Find field and check that LD2 (green Led) is enabled to PA5 pin as GPIO_Output.To verify that LD2 is set to GPIO_Output mode: This example shows the use of the green LED pin LD2 present on the NUCLEO-L476RG board as GPIO_Output. To see alternate pins for a signal, drag and drop the signal to a pin while keeping the Ctrl key pressed. (To configure LED pins, check in the STM32 Nucleo-64 boards User Manual and STM32L476xx Datasheet which LED pins to use).
When a board is selected, STM32CubeMX allows automatically the pinout setting for the board with the pin assignments for the communication interfaces, LEDs, and other functions. The corresponding pins PA13 and PA14 are assigned and configured automatically. Verify in Pinout tab, under SYS peripheral, that Serial Wire is selected as Debug interface: Answer Yes Initialize all peripherals with their default Mode ? popup.Select NUCLEO-L476RG board using Board selector:.
From Board Selector section, filter to select and use NUCLEO-L476RG board:.Click New Project or Menu -> File -> New Project.5 Configure project and generate source code.In this tutorial, we explain step-by-step how to blink a LED on the NUCLEO-L476RG board, using the STM32CubeMX tool, HAL, and STM32CubeIDE. How to build a “Blink LED” project from STM32CubeMX for ST/Atollic TrueSTUDIO® for STM32.UM1718 User manual STM32CubeMX for STM32 configuration and initialization C code generation.UM1884 Description of STM32L4/L4+ HAL and low-layer drivers.UM1724 User manual STM32 Nucleo-64 boards.The hardware requirements to start the application are the following: Previous Tutorial: Step1: Tools Installation and First test.program and use HAL functions to blink a LED on the NUCLEO-L476RG board.create and configure the STM32CubeMX project and generate the initialization code.This tutorial shows how to use the STM32CubeMX tool to initialize the peripherals, build and generate your starting projects with the initialization C code using HAL libraries.Īfter this tutorial, you should be able to: Blinking LED with STM32CubeMX and HAL 30min
0 kommentar(er)
